1. Manuals
  2. Brands
  3. HIKVISION Manuals
  4. Audio & Video Accessories
  5. DS-KAD308
  6. User manual

HIKVISION DS-KAD308 User Manual

Video/audio distributor
Hide thumbs Also See for DS-KAD308:
Table of Contents

Advertisement

Quick Links

Download this manual
Video/Audio Distributor
User Manual

Advertisement

Table of Contents
loading

Related Manuals for HIKVISION DS-KAD308

Summary of Contents for HIKVISION DS-KAD308

  • Page 1 Video/Audio Distributor User Manual...
  • Page 2 Trademarks and other Hikvision marks are the property of Hikvision and are registered trademarks or the subject of applications for the same by Hikvision and/or its affiliates. Other trademarks mentioned in this manual are the properties of their respective owners. No right of license is given to use such trademarks without express permission.
  • Page 3 Video/Audio Distributor·User Manual SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY OR CERTAIN DAMAGES, SO SOME OR ALL OF THE ABOVE EXCLUSIONS OR LIMITATIONS MAY NOT APPLY TO YOU. Support Should you have any questions, please do not hesitate to contact your local dealer.
  • Page 4 Video/Audio Distributor·User Manual Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
  • Page 5 Video/Audio Distributor·User Manual Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into Warnings and Cautions: Warnings: Neglecting any of the warnings may cause serious injury or death. Cautions: Neglecting any of the cautions may cause injury or equipment damage.
  • Page 6 Video/Audio Distributor·User Manual  Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can cause fire danger).  Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfunction however), and affecting the endurance of sensor at the same time.

  • Page 7: Table Of Contents

    1 Overview ...................... 1 1.1 Introduction ......................1 1.2 Main Features ......................1 2 Appearance ....................2 2.1 Front Panel/Back Panal of DS-KAD308/DS-KAD312 ..........2 2.2 Side Panel ........................ 3 2.2.1 Side Panel of DS-KAD308................... 3 2.2.2 Side Panel of DS-KAD312................... 4 3 Network Interface Description ..............

  • Page 8: Overview

    1 Overview 1.1 Introduction The video/audio distributor is designed for the video intercom products. It supports decoding and output analog video and audio signal, helps to realize the communication between indoor station and door station. Figure 1-1 Video/Audio Distributor 1.2 Main Features ...

  • Page 9: Appearance

    2 Appearance 2.1 Front Panel/Back Panal of DS-KAD308/DS-KAD312 Figure 2-2 Back Panel Figure 2-1 Front Panel Table 2-1 Components Description Description Signal Indicator Power Indicator...

  • Page 10: Side Panel

    2.2 Side Panel 2.2.1 Side Panel of DS-KAD308 Figure 2-3 DS-KAD308 Side Panel 1 Figure 2-4 DS-KAD308 Side Panel 2 Figure 2-5 DS-KAD308 Side Panel 3...

  • Page 11: Side Panel Of Ds-Kad312

    Table 2-2 Components Description Description Power Socket Network Interface DIP Switch Serial Port 2.2.2 Side Panel of DS-KAD312 Figure 2-6 DS-KAD312 Side Panel 1 Figure 2-7 DS-KAD312 Side Panel 2...
  • Page 12 Figure 2-8 DS-KAD312 Side Panel 3 Table 2-3 Components Description Description Power Socket Network Interface DIP Switch Serial Port...

  • Page 13: Network Interface Description

    3 Network Interface Description 3.1 Interface Description of DS-KAD308 Figure 3-1 Network Interfaces of DS-KAD308 Table 3-1 Descriptions of Interfaces Description Description Decoding Output Interface 1 Decoding Output Interface 6 Decoding Output Interface 2 Decoding Output Interface 7 Decoding Output Interface 3...

  • Page 14: Interface Description Of Ds-Kad312

    3.2 Interface Description of DS-KAD312 Figure 3-2 Network Interfaces of DS-KAD312 Table 3-2 Descriptions of Interfaces Description Description Decoding Output Interface 1 Decoding Output Interface 8 Decoding Output Interface 2 Decoding Output Interface 9 Decoding Output Interface 3 Decoding Output Interface 10 Decoding Output Interface 4 Decoding Output Interface 11 Decoding Output Interface 5...

  • Page 15: Dip Description

    4 DIP Description 4.1 DIP Description of DS-KAD308 Figure 4-1 DIP Switches of DS-KAD308 Table 4-1 Descriptions of RW1 and RW2 Digit (RW1) Function Floors Floors Reserved Room Room Room Reserved Mode (RW1) Digit (RW2) Function Floors Floors Floors Floors...
  • Page 16 Table 4-2 RW1 Configuration for Single Distributor Digit Floor No. (RW1) 1 floor with 8 households 2 floors with 4 Status households each 4 floors with 2 households each  * means irrelevant, ON means 1, OFF means 0.  Digit 1 and Digit 2 (RW1) are set as OFF by default, means 1 floor with 8 households. ...

  • Page 17: Configure Rw 2

    5 are OFF, it means 1 floor with 8 households. For example, if the RW1 is set as the table below, then the Room No. are 9, 10, 11, 12, 13, 14, 15 and 16. Table 4-5 RW1 Configuration Example of DS-KAD308 (for More than One Distributor) Digit (RW1) Status 4.1.2 Configure RW 2...

  • Page 18: Dip Description Of Ds-Kad312

    ON/OFF ON/OFF ON/OFF For example, if you set Digit1, Digit2 and Digit4 to be ON (as the table below), then the start floor No. is 11. That is, 1+2+8=11. Table 4-7 RW2 Configuration Example of DS-KAD308 Digit (RW2) Binary Value Status 4.2 DIP Description of DS-KAD312...

  • Page 19: Configure Rw 1

     The DIP switch (RW1) is used to configure the DIP rules. Digit 8 (RW1) is used to control the mode.  Before configure the device, set Digit 8 (RW1) as ON to adapt to the current indoor station version. ...
  • Page 20 Table 4-10 RW1 Configuration for More than One Distributor Digit Floor No. (RW1) 1 floor with 12 households 2 floors with 6 households each 3 floors with 4 Status households each 4 floors with 3 households each 6 floors with 2 households each ...

  • Page 21: Configure Rw 2

    Digit Room No. of (RW1)  * means irrelevant, ON means 1, OFF means 0.  Digit 4, Digit5 and Digit 6 (RW1) are set as OFF by default. When Digit4 and Digit5 are set as OFF, it means 1 floor with 12 households. For example, if you set the device as the table below, then the Room No.
  • Page 22 Digit (RW2) Binary Value Status ON/OFF ON/OFF ON/OFF ON/OFF ON/OFF ON/OFF ON/OFF ON/OFF For example, if you set Digit1, Digit2 and Digit4 to be ON (as the table below), then the start floor No. is 11. That is, 1+2+8=11. Table 4-14 RW2 Configuration Example of DS-KAD312 Digit (RW2) Binary...

  • Page 23: Typical Application

    5 Typical Application Building Client Software (PC) Video/Audio Distributor Resident 2 Resident 1 Video/Audio Distributor Resident 2 Resident 1 Center Master Station Video/Audio Distributor Resident 2 Resident 1 IP Camera Video/Audio Distributor Resident 2 Resident 1 Outer Door Station Door Station Figure 5-1 Typical Application of Video/Audio Distributor...

  • Page 24: Installation

    6 Installation The installation of DS-KAD308 and DS-KAD312 are same. Video/audio distributor can be set on a desk and also support wall mounting. The wall mounting steps as below: Steps: 1. Chisel two holes in the wall. The diameter of the hole is 3 mm, and the distance between two holes is 136 mm.

This manual is also suitable for:

Ds-kad312

Table of Contents