Error Messages - Husqvarna DMT 700 Operator's Manual

Error messages

Fault Message on
Code the display
U100087 I/O Controller
U100088 I/O Controller
P060745 IOC MPU
P060742 IOC MPU
C1F0612 Crank signal
Blade depth
C1E0111
sensor signal
Blade depth
C1E0112
sensor signal
C1D0115 Starter
C1D0111 Starter
Power supply
C1D0711
external device
Power supply
C1D0712
external device
C1D0815 AUX1
C1D0811 AUX1
C1D0215 AUX2
C1D0211 AUX2
C1D0315 Blade clutch
TROUBLESHOOTING
DTC description Indication on the machine
No CAN
communication
Software download
failed
Engine can not be started. No
machine function can be controlled.
Program memory
failure
General memory
failure
Circuit short to
Engine can not be started.
battery
Circuit short to
ground
Blade depth can not be displayed.
Blade depth stop can not be used.
Circuit short to
battery
Circuit short to Engine starter can not be controlled.
battery or open Cutting can not continue.
Circuit short to
Engine can not be started.
ground
Circuit short to
Cutting can not continue.
ground
Circuit short to May not be able to read sensor
battery values.
Circuit short to
battery or open
AUX1 can not be controlled by the
HMI.
Circuit short to
ground
Circuit short to
battery or open
AUX2 (5th wheel) can not be
controlled by the HMI.
Circuit short to
ground
Blade clutch can not be controlled by
Circuit short to
the HMI. Blade might be engaged or
battery or open
disengaged the whole time.
Possible action
Check damage to connectors X1, X4,
X14 and chassis harness. If found,
repair and restart system, reset fault
code.
If problem still exists, contact your
service agent for further information.
Contact your service agent.
Contact your service agent for further
information.
Check damage to key switch, key switch
connectors X30, X32 and harness. If
found, repair and restart system, reset
fault code.
Disconnect sensor and reset fault code.
If fault code no longer exists check
sensor and sensor harness.
Check damage to X13 and X14
connectors and harness to sensors. If
found, repair and restart system, reset
fault codes.
Contact your service agent for further
information.
Check damage to X14 and X1
connector and harness. If found, repair
and restart system, reset fault code.
It problem still exists, contact your
service agent for further information.
Check cables to:
Blade depth sensor and sensor itself
E-track position sensor and sensor itself
Neutral start switch and switch itself
Lower/raise switch and switch itself
Water safety switch and switch itself
Check K4 relay in relay/fuse box.
Check damage to X14 connector,
harness to relay/fuse box and relay/fuse
box connector. If found, repair and
restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Check K5 relay in relay/fuse box.
Check damage to X14 connector,
harness to relay/fuse box and relay/fuse
box connector. If found, repair and
restart system, reset fault code.
If problem still exists, contact your
service agent for further information.
Check K7 in relay/fuse box.
English
– 39