Operator Keyboard Cabling; Printer Cabling; Color Monitor Cabling; Engineer's Keyboard Cabling - Honeywell Enhanced Micro TDC 3000 User Manual

2.7.5 Operator Keyboard Cabling

Connect the keyboard cable to the connector on the face plate of the EPDGC I/O board (see
Figure 2-11). Use a small screwdriver to tighten the screws (2) on the connector.

2.7.6 Printer Cabling

The printer cable (51303631-003) has similar connectors on each end.
1. Connect the end of the cable marked
EPDGC I/O board marked
the screws (2) on the connector.
2. Connect the other end of the printer cable (marked
Using a small screwdriver, tighten the screws (2) on the connector.

2.7.7 Color Monitor Cabling

Connect the cable from the color monitor to the EPDGC I/O face plate connector marked
in Figure 2-11. on the upper transition panel. Using a small screwdriver, tighten
VIDEO
the screws (2) on the connector. Finally, attach the power cord to the monitor and plug it
in.

2.7.8 Engineer's Keyboard Cabling

Insert the plug on the cable from the engineer's keyboard into the small connector located
on the right of the operator keyboard. Note the plug will only fit one way.

2.7.9 TPLCN Cabling

The two (2) TPLCN cables (51304505-100) have similar connectors on each end. The
standard cable length is 5 feet (1.5 meters). The optional cable (Option number
MX-MTLC11) is 33 feet (10 meters) long, allowing a maximum distance between towers
of 10 meters. The cable set connects directly to the TP-485 board face plates in the towers.
1. Attach one cable plug to the TP-485 face plate connector marked
cable plug to
BUS B
screws (2) on the connectors.
2. Attach the other end of the cable to the TP-485 face plate connector marked
the other cable plug to
tighten the screws (2) on the connectors.
3. Attach the ground wires to the small screws, if they are on your cable.
Enhanced Micro TDC 3000 User's Manual
to the connector on the face plate of the
PIC
in Figure 2-11. Use a small screwdriver to tighten
PRINTER
at the rear of Tower #1. Using a small screwdriver, tighten the
at the rear of Tower #2. Use a small screwdriver to
BUS B
2-14
) to the back of the printer.
PRINTER
and the other
BUS A
2.7.5
and
BUS A
9/95