Makita 1100 Instruction Manual page 6

2
3
4
5
► 1 . Bolts 2. Drum 3. Planer blade 4. Drum plate
5. Adjusting plate
Place the blade on the gauge base so that the blade edge
is perfectly flush with the inside edge of the gauge plate.
Place the adjusting plate on the blade, then simply press
in the heel of the adjusting plate flush with the back side
of the gauge base and tighten two screws on the adjusting
plate. Now slip the heel of the adjusting plate into the drum
groove, then fit the drum plate on it. Tighten all the installa-
tion bolts evenly and alternately with the socket wrench.
2
3
4
5
6
7
► 1. Inside edge of gauge plate 2. Blade edge 3. Planer
blade 4. Adjusting plate 5. Screws 6. Heel 7. Back
side of gauge base 8. Gauge plate 9. Gauge base
For tool with mini planer blades
1. Remove the existing blade, if the tool has been in
use, carefully clean the drum surfaces and the drum
plate. To remove the blades on the drum, unscrew
the three installation bolts with the socket wrench.
The drum plate comes off together with the blades.
1
1
8
9
1
2
3
4
► 1 . Pan head screw 2. Adjusting plate 3. Planer
blade locating lugs 4. Gauge plate 5. Heel of adjust-
ing plate 6. Set plate 7. Inside flank of gauge plate
8. Gauge base 9. Back side of gauge base 10. Mini
planer blade
2. To install the blades, loosely attach the adjusting
plate to the set plate with the pan head screws
and set the mini planer blade on the gauge base
so that the cutting edge of the blade is perfectly
flush with the inside flank of the gauge plate.
3. Set the adjusting plate/set plate on the gauge
base so that the planer blade locating lugs on the
set plate rest in the mini planer blade groove, then
press in the heel of the adjusting plate flush with
the back side of the gauge base and tighten the
pan head screws.
4. It is important that the blade sits flush with the
inside flank of the gauge plate, the planer blade
locating lugs sit in the blade groove and the heel
of the adjusting plate is flush with the back side of
the gauge base. Check this alignment carefully to
ensure uniform cutting.
5. Slip the heel of the adjusting plate into the groove
of the drum.
► 1 . Mini planer blade 2. Groove 3. Set plate 4. Hex.
flange head bolt 5. Drum plate 6. Drum 7. Adjusting
plate
6. Set the drum plate over the adjusting plate/set
plate and screw in the three hex flange head bolts
so that a gap exists between the drum and the set
plate to slide the mini planer blade into position.
The blade will be positioned by the planer blade
locating lugs on the set plate.
6 ENGLISH
1
7
3
2
5
6
7
8
9
10
6
5
4