PC SERIES BUILT-IN GAS HOBS CE Certificate no. 51 INSTRUCTION, USE AND MAINTENANCE BOOKLET MODELS LIST 28/09/2010 Type: PC Qn - kW no. Model Brand Nominal Voltage Electric power 1 PC1320 1,90 2 PC1321 3,80 3 PC1322 3,80 4 PC1323...
Page 3
Manufacturer: CAN di Bellini Mauro Via Nazionale, 65 - 25080 PUEGNAGO DEL GARDA (BS) TEL +39.0365/555909 r.a. - FAX+39.0365/651 822 www.can-web.com - info@can-web.com...
GENERAL WARNINGS Before using the appliance, read this booklet carefully. Keep it safely for every further need and for any technical servicing. Tis appliance must be installed in compliance with the regulations in force and used only in a well ventilated environment. See the instructions before installing and using this appliance.
Page 5
INSTRUCTIONS FOR USE The series of glass hobs comprises the models shown in the following table, which summarises the feature of the burners: PC1320 PC1321 PC1322 - 1 Semirapido (1900 W) - 2 Semirapido (1900 W) - 2 Semirapido (1900 W) PC1323 - 1 rapido (3000w) - 1 semirapido (1900 W)
Page 6
To fully understand this booklet, check which model you have just purchased. Each model has: above each knob, a diagram indicating the burner to which the knob refers; 1/2/3 burners. Each burner consists of: metal cover; aluminium fame divider resistant to high temperatures (PYRAL); stainless steel heat shield flange with built-in pan stand;...
Page 7
The burner parts that can be dismantled for ordinary cleaning are the cap and flame divider. Do not use tools to dismantle the parts. The removal of other burner parts is forbidden. When cleaning the cut-off device, operate gently using a wet sponge.
Page 8
INSTALLATION – MAINTENANCE – ADJUSTMENTS The information and operations illustrated in this section are dedicated exclusively to fitters. The installation and all adjustments, transformations and maintenance operations shown in this section must be carried out exclusively by qualified personnel, in observance of local legislation (Law no.
Page 9
(at least 2 m /h for each kW of installed power). This can be obtained by taking the air directly from outside (section of at least 100 cm , in order to prevent it becoming accidentally blocked), or indirectly from adjacent rooms (not bedrooms or rooms where there is a risk of explosion) which are directly ventilated and connected to the former by permanent openings.
Page 10
Replace everything necessary, always fitting original parts supplied by Technical Assistance. The washers in contact with gas (e.g.: those of the valves) must always be replaced when implicated in disassembly). Restore any seals when the replacement operation is complete. If it becomes necessary to replace the injectors, see the TECHNICAL FEATURES section. No sealant is used between the injector thread and its seat.
The appliance is compliant with the indications of the following European Directive: 90/396/CEE + 93/68 (Gas Directive) and with the European Standards EN 30 (Domestic gas cooking appliances). This appliance is guaranteed by CAN. The warranty implicates the free repair or replacement of parts presenting manufacturing faults.
Page 12
FC SERIES RETRACTABLE GAS HOBS INSTRUCTION, USE AND MAINTENANCE BOOKLET MODELS LIST 28/09/2010 Type: Qn - n° Model Brand Nominal Electric Voltage power 1 FC1345 CAN 1,90 2 FC1347 CAN 4,80 3 FC1348 CAN 2,90 4 FC1336 CAN 2,90...
Page 13
Manufacturer: CAN di Bellini Mauro Via Nazionale, 65 - 25080 PUEGNAGO DEL GARDA (BS) TEL +39.0365/555909 r.a. - FAX+39.0365/651 822 www.can-web.com - info@can-web.com...
Page 14
GENERAL WARNINGS Before using the appliance, read this booklet carefully. Keep it safely for every further need and for any technical servicing. Tis appliance must be installed in compliance with the regulations in force and used only in a well ventilated environment. See the instructions before installing and using this appliance.
Page 15
INSTRUCTIONS FOR USE The series of glass hobs comprises the models shown in the following table, which summarises the feature of the burners: FC1345 FC1336 FC1347 - 2 Semi-fast (1900 W) - 1 Semi-fast (1900 W) - 1 Semi-fast (1900 W) - 1 Auxiliary (1000 W) - 1 Auxiliary (1000 W) FC1348...
Page 16
The pan stands and stainless steel accessories burnish when the appliance has been operating for a few minutes. This colouring can be removed using a finely abrasive pad. The shine of stainless steel parts can be maintained by washing them with warm soapy water. Periodical cleaning with a special product for cleaning steel is recommended.
Page 17
The burner parts that can be dismantled for ordinary cleaning are the cap and flame divider. Do not use tools to dismantle the parts. The removal of other burner parts is forbidden. When cleaning the cut-off device, operate gently using a wet sponge.
Page 18
Make sure that the distance between the pan stand of the appliance and any furniture of hoods above the appliance is at least 650 Any lateral work surfaces within critical distance Y must remain below the height of the appliance surface. When the appliance is in use the bottom may feel hot, while remaining within the limits indicated by the reference standard ( EN 30).
Page 19
(at least 2 m /h for each kW of installed power). This can be obtained by taking the air directly from outside (section of at least 100 cm , in order to prevent it becoming accidentally blocked), or indirectly from adjacent rooms (not bedrooms or rooms where there is a risk of explosion) which are directly ventilated and connected to the former by permanent openings.
Page 20
Figure 4 thermocouple Copper ramp Injector cup Stainless steel ramp valve Proceed with reassembly. Greasing the valves: if the rotation of the knob becomes difficult, it is necessary to grease the valve to prevent damage. Proceed as follows: dismantle the valve from the gas ramp and the internal tubes; dismantle the body of the valve;...
Page 22
The appliance is compliant with the indications of the following European Directive: 90/396/CEE + 93/68 (Gas Directive) and with the European Standards EN 30 (Domestic gas cooking appliances). This appliance is guaranteed by CAN. The warranty implicates the free repair or replacement of parts presenting manufacturing faults.
Page 23
FN SERIES FREE-STANDING GAS HOBS EC Certificate no. 51 INSTRUCTION, USE AND MAINTENANCE BOOKLET MODELS LIST 28/09/2010 Type: FN Qn - kW Model Brand Nominal Electric Voltage power FN1330 1,90 FN1331 1,90 FN1332 2,90 FN1333 3,80 FN1334 3,80 FN1335 5,90...
Page 24
MANUFACTOR: CAN di Bellini Mauro Via Nazionale, 65 - 25080 PUEGNAGO DEL GARDA (BS) TEL +39.0365/555909 r.a. - FAX+39.0365/651 822 www.can-web.com - info@can-web.com...
Page 25
GENERAL WARNINGS Before using the appliance, read this booklet carefully. Keep it safely for every further need and for any technical servicing. This appliance must be installed in compliance with the regulations in force and used only in a well ventilated environment. See the instructions before installing and using this appliance.
Page 26
INSTRUCTIONS FOR USE The series of glass hobs comprises the models shown in the following table, which summarises the feature of the burners: FN1330 FN1331 FN1332 - 2 Semirapid (1900 W) - 1 Semirapid (1900 W) - 1 Semirapid (1900 W) - 1 Auxiliary (1000 W) FN1333 FN1334...
Page 27
The pan stands and stainless steel accessories burnish when the appliance has been operating for a few minutes. This colouring can be removed using a finely abrasive pad. The shine of stainless steel parts can be maintained by washing them with warm soapy water. Periodical cleaning with a special product for cleaning steel is recommended.
Page 28
The burner parts that can be dismantled for ordinary cleaning are the cap and flame divider. Do not use tools to dismantle the parts. The removal of other burner parts is forbidden. When cleaning the cut-off device, operate gently using a wet sponge.
Page 29
INSTALLATION – MAINTENANCE – ADJUSTMENTS The information and operations illustrated in this section are dedicated exclusively to fitters. The installation and all adjustments, transformations and maintenance operations shown in this section must be carried out exclusively by qualified personnel, in observance of local legislation (Law no.
Page 30
(at least 2 m /h for each kW of installed power). This can be obtained by taking the air directly from outside (section of at least 100 cm , in order to prevent it becoming accidentally blocked), or indirectly from adjacent rooms (not bedrooms or rooms where there is a risk of explosion) which are directly ventilated and connected to the former by permanent openings.
Page 31
Restore any seals when the replacement operation is complete. If it becomes necessary to replace the injectors, see the TECHNICAL FEATURES section. No sealant is used between the injector thread and its seat. Figure 4 Cut-off device Stainless steel ramp Injector cup Copper ramp valve...
Page 32
The following tables show the technical data for each burner, in relation to the appliance categories. For category: I3+ Nominal Nominal Reduced Nozzle Pressure heat diameter heat heat Burner (1/100 mm) (mbar) capacity capacity capacity (g/h) - MINIMUM - 28 – 30 G30 (Butane) Auxiliary 1000...
Page 33
The appliance is compliant with the indications of the following European Directive: 90/396/CEE + 93/68 (Gas Directive) and with the European Standards EN 30 (Domestic gas cooking appliances). This appliance is guaranteed by CAN. The warranty implicates the free repair or replacement of parts presenting manufacturing faults.
Page 34
PV SERIES BUILT-IN GLASS HOBS CE Certificate no. 51Bu3860 INSTRUCTION, USE AND MAINTENANCE BOOKLET 13/05/2009 MODELS LIST TYPE :PV Qn - kW Model Brand Nominal Electric Voltage power 1 PV1350 1,90 2 PV1351 2,90 3 PV1352 5,90 4 PV1357 4,90 5 PV1360 3,80 6 PV1361...
Page 35
Manufacturer: CAN di Bellini Mauro Via Nazionale, 65 - 25080 PUEGNAGO DEL GARDA (BS) TEL +39.0365/555909 r.a. - FAX+39.0365/651 822 www.can-web.com - info@can-web.com...
Page 36
GENERAL WARNINGS Before using the appliance, read this booklet carefully. Keep it safely for every further need and for any technical servicing. Tis appliance must be installed in compliance with the regulations in force and used only in a well ventilated environment. See the instructions before installing and using this appliance.
Page 37
INSTRUCTIONS FOR USE The series of glass hobs comprises the models shown in the following table, which summarises the feature of the burners: PV 1350 PV 1351 PV 1352 - 1 Semi-fast (3000 W) - 1 Semi-fast (1900 W) - 1 Semi-fast (1900 W) - 1 Semi-fast (1900 W) - 1 Auxiliary (1000 W) - 1 Auxiliary (1000 W)
Page 38
The pan stands and stainless steel accessories burnish when the appliance has been operating for a few minutes. This colouring can be removed using a finely abrasive pad. The shine of stainless steel parts can be maintained by washing them with warm soapy water. Periodical cleaning with a special product for cleaning steel is recommended.
Page 39
The burner parts that can be dismantled for ordinary cleaning are the cap and flame divider. Do not use tools to dismantle the parts. The removal of other burner parts is forbidden. When cleaning the cut-off device, operate gently using a wet sponge.
Page 40
INSTALLATION – MAINTENANCE – ADJUSTMENTS The information and operations illustrated in this section are dedicated exclusively to fitters. The installation and all adjustments, transformations and maintenance operations shown in this section must be carried out exclusively by qualified personnel, in observance of local legislation (Law no.
Page 41
(at least 2 m /h for each kW of installed power). This can be obtained by taking the air directly from outside (section of at least 100 cm , in order to prevent it becoming accidentally blocked), or indirectly from adjacent rooms (not bedrooms or rooms where there is a risk of explosion) which are directly ventilated and connected to the former by permanent openings.
Page 42
the conditions of the system (any narrowing of the connections; the appliance supply pressure is stated on the plate) or of the pressure regulator fitted to the gas bottle. The appliance is in category one (I3+ or I3B/P), so no transformation for use with other types of gas is possible. The dismantling of the injectors for switching to other types of gas is not allowed.
Page 43
AFTER COMPLETING EACH REASSEMBLY, ALWAYS CHECK THAT THE SEAL CONFORMS TO THE INSTALLATION STANDARDS IN FORCE. THE USE OF A NAKED FLAME IS STRICTLY FORBIDDEN. TECHNICAL FEATURES Installation class: Fastening method: M.S. SUPER silicone Appliance category: Gas (group) and supply pressure: Total burner power (Q * see the plate on the first page, in accordance with the country of destination The following tables show the technical data for each burner, in relation to the appliance categories.
Page 44
The appliance is compliant with the indications of the following European Directive: 90/396/CEE + 93/68 (Gas Directive) and with the European Standards EN 30 (Domestic gas cooking appliances). This appliance is guaranteed by CAN. The warranty implicates the free repair or replacement of parts presenting manufacturing faults.
Page 48
Can di bellini mauro Via nazionale N°65 25080 PUEGNAGO DEL GARDA TEL: +390365/555909 r.a. FAX: +390365/651822 WWW.CAN-WEB.COM...