Cisco 7513-MX Maintaining page 14

Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Figure 7-11
Carefully guide the cover up and away from the chassis.
Step 3
See the appropriate sections depending on the replacement procedures you need to perform. Then, to
Note
replace the maintenance cover, proceed to Step 4.
Replace the maintenance cover by carefully guiding the cover over the ten screws.
Step 4
Align the cover; then tighten all ten screws that secure it to the chassis.
Step 5
This completes the backplane maintenance cover removal and replacement procedure.
Removing and Replacing the Chassis Interface in the Cisco 7513, Cisco
7513-MX, and Cisco 7576
In the Cisco 7513, Cisco 7513-MX, and Cisco 7576, the chassis interface (CI) (shown in
provides environmental monitoring and logic functions. The Cisco 7513 and Cisco 7513-MX has one
chassis interface, and the Cisco 7576 has two chassis interfaces.
Cisco 7500 Series Installation and Configuration Guide
7-14
Chapter 7
Removing the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Backplane Maintenance
Cover
Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router
Loosen these
screws (10)
Figure 7-12)
OL-5008-03 B0