Table of Contents
Advertisement
Chapter 7
Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router
When the blower is all the way into the chassis opening, tighten the captive installation screws on the
Step 4
front of the blower module.
This completes the blower module removal and replacement procedure.
Removing and Replacing the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Chassis Cover Panels
Each cover panel on the Cisco 7513, Cisco 7513-MX, and Cisco 7576 has four fasteners that secure the
panels to the front of the chassis. The following procedures describe how to remove and replace the front
cover panels.
Step 1
Use a 3/16-inch flat-blade screwdriver to gently loosen the top of each cover panel.
Pull the top of the upper panel out about 2 inches (5.08 cm); grasp the sides and carefully pull it outward,
Step 2
away from the chassis. Repeat this for the bottom panel.
See the appropriate sections depending on the replacement procedures you need to perform. Then, to
Note
replace the chassis cover panels, proceed to Step 3.
OL-5008-03 B0
Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Cisco 7500 Series Installation and Configuration Guide
7-11
Advertisement
Table of Contents
