Honeywell ML200 Series Installation And Commissioning Manual page 61

Code Error Causes
44 Use of Timer
Index error
50 Error of external
device is detected
by a user
program during
operation
60 E_STOP function
execution
101 CPU position
error
102 Duplicated CPU
ID error
103 Base abnormal
error
104 System
configuration
error
Measures
Restart mode after the
measure.
Modify the timer index
program, reload, and
start.
Repair a fault device by
referring to error
detection flag of external
device and restart
(according to
parameter).
Eliminate the causes of
error operating E_STOP
function in the program
and turn it on again.
CPU is installed at
wrong position. Position
the CPU correctly.
Set the A/B side
switches of master CPU
and standby CPU
differently.
Configure the expansion
cable as ring topology
and position the
detached base correctly.
For information of
detached base, refer to
the CPU error log.
Check for dual IO link
redundancy
configuration and ring
topology.
Check redundancy
l
drive module station
number.
Check the version of
l
the operating system
of the expansion drive
module and the
expansion manager.
- 59 -
Chapter 4 - Troubleshooting
Operation LED
Status Status
STOP RUN:
(RUN) OnERR :
On
STOP ERR : On
(RUN) (P.S. :
On)
STOP RUN:
OnERR :
On
STOP S101
STOP S102
STOP, E103
RUN
STOP E104
Diagnostic
Timing
When scan
ends.
When scan
ends.
When
program is
executed.
Turn it on.
Turn it on.
Execute
program.
When the
scan ends,
turn it on.