Cannot Log In To The Router - NETGEAR Nighthawk Mesh WiFi 6 System User Manual

To sync the router and the satellite:
1. Place the satellite in the same room as the router.
Use this satellite location only during the sync process.
2. Connect the satellite to a power source.
3. Press the Sync button on the router and then within two minutes, press the Sync
button on the satellite.
4. Wait for the satellite LED to light.
The satellite LED pulses white while it attempts to sync with the router. After the LED
pulses white, it lights one of the following colors:
• Blue. The router and satellite successfully synced, and the connection between
the router and satellite is good.
• Amber. The router and satellite failed to sync. Try repeating Step 3 again. If the
sync keeps failing, try moving the satellite to a different location that's closer to
the router.
5. Move the satellite to a new location and connect the satellite to a power source.
6. At the new location, check the satellite LED and make sure it lights blue.
If the satellite LED lights blue, the satellite synced successfully. If the satellite LED
lights amber, move the satellite closer to the router and try again. The satellite must
be within range of the router's WiFi cover area for a good connection to the router.

Cannot Log In to the Router

Make sure that your computer or mobile device is connected to your mesh WiFi network.
If you do not want to use a WiFi connection, you can connect your computer to the
router with an Ethernet cable.
If you changed the admin password and you forgot what it is, see Change the admin
password on page 79.
Troubleshooting
Nighthawk Mesh WiFi 6 System
116 User Manual