Fm Wire Antenna; Speaker Connections - Philips FW396C/22 User Manual

A AM Loop Antenna
Connection
Connect the supplied loop antenna to the
AM AERIAL terminal. Place the AM loop
antenna far away from the system and
adjust its position for the best reception.
B FM Wire Antenna
Connection
Connect the supplied FM wire antenna to
the FM 75 terminal. Adjust the position
of the FM antenna for the best reception.
Outdoor Antenna
For better FM stereo reception connect an
outdoor FM antenna to the FM AERIAL 75
terminal using a 75 coaxial wire.
C Speaker Connections
• Connect the right speaker to Front
terminal R, with the red wire to + and
the black wire to -.
• Connect the left speaker to Front
terminal L, with the red wire to + and
the black wire to -.
• Clip the stripped portion of the speaker
wire as shown.
12 mm
unlock lock
Untitled-1 7
D Connecting other
equipment to your system
You can connect the audio left and right
OUT terminals of a TV, VCR, Laser Disc or
DVD player to the AUX IN terminals at the
rear of the system.
E Subwoofer Out Connection
You can connect either an optional active
subwoofer or an optional wireless active
subwoofer to the SUBWOOFER OUT
terminal. The wireless system uses a radio
frequency transmitter. The subwoofer
reproduces just the low bass effect (e.g.
explosions, the rumble of the spaceships,
etc.). Be sure to follow the instructions
supplied with the subwoofer unit.
Note:
– Availability of wireless transmitter and
its peripherals are subjected to the
approval of local authorities. Please
check with respective local safety or
approving authority.
F Digital Out Connection
You can record the digital sound from the
CD, through this output, on any audio
equipment with digital input (e.g. CD
Recorder, Digital Audio Tape (DAT) deck,
Digital to Analog Converter and Digital
Signal Processor).
Connect one end of the cinch cable (not
supplied) to the DIGITAL OUT socket and
the other end to the audio equipment with
digital input.When connecting the cinch
cable, make sure it is fully inserted.
G AC Power Supply
After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.
6/15/00, 2:04 PM
PREPARATION
Inserting batteries into the
Remote Control
• Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.
• To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.
3139 116 19271
7