Recording - Philips FW-C55/25 User Manual

Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 with full spool to the left and a
blank tape into tape deck 2 with full
spool aside.
3 Press í or ë to select the recording
tape side (see Tape Side under TAPE
section) .
4 Press DUB (HSD) once for normal
speed dubbing or twice (within 2
seconds) for high speed dubbing.
™ "NORMAL" (normal speed) or
"FAST" (high speed) will be
displayed, followed by "DUB" with
"< or >" scrolling left or right
depending on the tape side selected.
™ The appears on the display
HSD
during high speed dubbing.
• Dubbing will start immediately.
™ The starts flashing.
REC
5 Press Ç to stop dubbing.
Notes:
– Only å å å å å mode is available during
dubbing.
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
22
pg 01-26/C55-C58/34-En 22
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
– Dolby NR button has no influence during
dubbing (dubbing from tape deck 1 to
tape deck 2). An original tape recorded
with Dolby B NR automatically produces
a copy with Dolby B NR.
CD Synchro Start Recording
1 Load a blank tape into tape deck 2 and a
disc into a disc tray.
2 Press CD to select CD mode.
• You can program the tracks in the order
you want them to be recorded (see
Programming Tracks). If not, select the
disc by pressing CD (CD 1•2•3) and the
tracks are recorded according to the
order on the selected disc.
3 Press REC to start recording.
™ The starts flashing.
REC
• CD will start playback automatically.
4 Press Ç to stop recording.
Recording the mixed sound /
One Touch Recording
• During microphone mixing, you can
record the mixed sound on a tape in
tape deck 2 except dubbing mode.
• For One Touch Recording, as soon as you
press REC, the current source (CD,
TUNER or AUX) will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
™ The starts flashing.
REC
3 Press Ç to stop recording.
Note:
– When you press RECORD while in TAPE
mode, " SELECT SOURCE " will be
displayed. One Touch Recording is not
possible in TAPE mode.
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.
2/22/00, 7:01 PM

RECORDING

3139 116 19541