Huawei FusionModule1000A40 ICT Solution Maintenance Manual page 38

FusionModule1000A40 ICT Solution
Maintenance Guide
Check
Item
Door status
switch
Issue 01 (2019-03-05)
Operation Check Standard
RUN Blinking slowly:
indicator The software runs
properly (the
indicator blinks at
0.5 Hz, on for 1s
and then off for 1s)
or registration with
the ECC800 is
successful.
Blinking at short
interval: The
communication is
interrupted or the
registration with the
ECC800 fails (the
indicator blinks at 4
Hz, on for 0.125s
and then off for
0.125s).
WPS On: The WPS is
indicator working properly.
Blinking: The WPS
is in matching
mode. If the
matching fails, the
WPS indicator turns
off after blinking
for 2 minutes. If the
matching is
successful, the WPS
indicator turns off.
Open a door An access alarm is
with a status generated on the
sensor, and ECC800 WebUI.
check the
alarm
information
displayed on
the
monitoring
software
terminal.
Copyright © Huawei Technologies Co., Ltd.
3 Routine Maintenance
Troubleshooting
Check the power supply.
Refer to ECC800 Data Center
Controller V100R001C30 User
Manual to register the device, or
contact Huawei technical support.
For details, contact Huawei technical
support.
If no alarm is generated when a door
with a status sensor is opened,
replace the door status sensor by
following instructions in 4.3.11.6
Replacing a Door Status Sensor.
31