Zero Configuration Setup - D-Link DCS-935L User Manual

Section 2 - Installation
If you have a mydlink-enabled Cloud Router and an active mydlink account, you can use Zero Configuration Setup. Your
Cloud Router will automatically assign your network settings to your camera, and add it to your mydlink account. This allows
you to set up your camera by simply plugging it in and connecting it to your router. After setup is complete, you can remotely
access your camera from the website (http://www.mydlink.com).
If you do not have a D-Link Cloud Router, skip to "Mobile App Setup" on page 18. To learn more about mydlink, refer to
"What is mydlink?" on page 21.
Plug in the External Power Adapter
Attach the power adapter to the power connector (Micro USB port) on the back of the
camera, and plug the power adapter into a wall outlet or power strip. Power is confirmed
when the Power LED is lit.
Press the WPS Button on Your Camera
Press and hold the WPS button on the back of the camera for three seconds. The blue
WPS status LED will start blinking.
Press the WPS Button on Your Cloud Router
Press the WPS button on your Cloud Router within 60 seconds. The WPS button is usually
on the side or back of your Cloud Router. The DCS-935L will automatically create a secure
wireless connection to your router and reboot. When it has successfully connected, the
Power LED will be lit green and the Direct LED will be off.
D-Link DCS-935L User Manual

Zero Configuration Setup

Power Connector
WPS Button
WPS Button
15