Connect audio receiver
AUDIO
AUDIO
OUT
OUT
DIGITAL
AUDIO
OUT
To select connected equipment
Press the v key on the remote control repeatedly to select
according to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
Cinema Link Surround receiver
See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Recorder or DVD with EasyLink
The recorder (VCR or DVD+ RW or DVD can be
operated with the remote control via the
or
menu on screen.
Recorder
DVD
Recorder
Ò
Rwd Play
DVD
Ò
p
Prev. Play
MultiChannel surround receiver with or without digital
input connectors
&
é
CENTRE IN
CENTRE IN
CENTRE IN
"
'
(
p
‡
π
†
Stop Play
Ffw
‡
π
†
Stop Play
Next Eject
Although your TV is already equipped with a Digital
MultiChannel decoder you might want to connect your own
MultiChannel surround receiver.
Connect a MultiChannel surround receiver to the
and
connectors at the back of your TV.
R
L
If you want the loudspeakers of your TV to act as centre
speaker, also connect an audiocable to the MultiChannel
surround receiver
CENTRE OUT
connector at the back of your TV.
CENTRE IN
Select
Centre input On
loudspeakers of the TV will now only produce centre sound.
If necessary, adjust the volume level of the centre sound in the
menu item of the Source menu.The overall
Centre in volume
volume has to be controlled via the MultiChannel surround
receiver.
In case of a Digital MultiChannel surround receiver, also connect
the receiver to the digital audio out connector.
In this case the loudspeakers of your TV cannot act as centre
speaker. Select
Centre input Off
Also see the instructions manual of your Digital MultiChannel
surround receiver.
EXT1
&
Press the
é
Select the
cursor up/down.
"
Press the cursor left/right, up/down to select
one of the recorder or DVD functions.
®
Ï
The key ® for recording can be operated in the TV
Rec Eject
mode.
If your EasyLink recorder has the system standby
function, when you press the B key for 3 seconds,
Ï
both TV and the recorder are switched to standby.
connector and to the
in the Source menu. See p. 11.The
in the Source menu, see p. 11.
,
,
,
EXT2
EXT3
EXT4
key on the remote control.
MENU
or
Recorder
DVD
AUDIO OUT
CENTRE IN
or
SIDE
menu with the
23