Portable Comfort Control - Honeywell Prestige IAQ THX9000 System Installation Manual

2-wire Prestige® IAQ and RF EIM
Replacing system components
Equipment Interface Module (Continued)
Yes
3. Link thermostat to the new Equipment Interface Module (see pages
6–7)
Thermostat
After installing a new thermostat, you must link the new thermostat to the
Equipment Interface Module, as described below.
1. Install and wire new thermostat (see pages 3-7).
2. Link thermostat to Equipment Interface Module (see pages 6–7).

Portable Comfort Control

1. Press and hold the blank space (or arrow if present) in the lower
right corner of the screen until the display changes (see page 8).
2. Press REMOVE, then yes to disconnect from old Equipment Interface
Module.
3. Follow the procedure on pages 7–8 to link to new Equipment
Interface Module.
Outdoor air sensor
1. Press the connect button to link to the new Equipment Interface
Module (see page 7).
How to disconnect all devices from the wireless network
at the same time
S 2
C O N N E C
S 2
T E D
S 1
C O N N E C
T S 1
69-2445EFS—03
MCR32407
Press and hold the Connect button at the
CONNECT
LED
Equipment Interface Module until the LED flashes
CONNECT
amber (about 10 seconds).
BUTTON
NOTE: To get the Portable Comfort Control back
to the connect screen, follow the instructions
M32399
below.
Portable Comfort Control
Press and hold the blank space (or arrow, if
present) in the lower right corner of the screen
until the display changes (about 3 seconds).
Press YES.
14
M32408