Appendix E - Regulatory Compliance; Federal Communication Commission Interference Statement; Important Note - Fcc Radiation Exposure Statement - Buffalo AirStation WHR-300HP Manual

Hide thumbs Also See for AirStation WHR-300HP:

Table of Contents

Appendix E - Regulatory Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pur-

suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is en-

couraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-

tions: (1) This device may not cause harmful interference, and (2) this device must accept any inter-

ference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment.

This equipment should be installed and operated with minimum distance 20cm between the radia-

tor and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or trans-

mitter.

The availability of some specific channels and/or operational frequency bands are country depen-

dent and are firmware programmed at the factory to match the intended destination. The firmware

setting is not accessible by the end user.

- 10 -

Table of Contents