Power On Announcement; Bluetooth® Interface; Pairing And Unpairing Bluetooth Devices; Internal Recorder And Playback - Honeywell Bendix/King KMA 30 Manual

It will take about 10 seconds to go from minimum to maximum volume.

3.11.5 Power on announcement

If the Intercom or Music Distribution is changed from the factory default, the configuration will be
played when the unit is powered up. To defeat this announcement, hold the TEL and AUX buttons when
for more than two seconds. The feature can be enabled again using the same sequence.
3.12 Bluetooth® interface
The KMA 30 has a Bluetooth interface. The audio panel is always "discoverable," so you just need to
search for the KMA 30 from your Bluetooth-equipped phone or music source. The default access code is
0000, if needed. Once the KMA 30 has been "paired" with your Bluetooth device, the TEL distribution
will act as described in § 3.4.
You can answer a call by pushing the TEL button while it is ringing. Calls can be answered from the tele-
phone handset or the audio panel. You can disconnect from either the handset or the audio panel. When a
call is disconnected or dropped, the TEL button indicator will extinguish after a few moments.

3.12.1 Pairing and unpairing Bluetooth devices

The KMA 30 can be paired with up to eight individual devices. When that number is exceeded, one device
will be automatically un-paired to allow the new device. The device eliminate will be selected at random
by the Bluetooth module. Hint, if your old phone is not recognized by the KMA 30, you may simply need
to re-pair.
3.12.1.1 Paring separate music and telephone devices
It is possible to use a different music source (iPad, iPod with Bluetooth adapter, Bluetooth enabled laptop,
etc) and telephone. However, the music source must be paired first, before the telephone, if the telephone
also has music streaming capability. Otherwise, the Smartphone will also take over the music streaming.
3.12.1.2 Changing access codes
If desired, you can change the 4-digit code needed to pair your device. Hold the button shown in the fol-
lowing table, and turn the KMA 30 on. You will hear a tone indicating that the code was changed.
Table 3-5 Bluetooth PIN codes

3.13 Internal Recorder and playback

The KMA 30 comes equipped with an internal recorder. This digital system stores the last incoming audio
from the radio you have selected for transmit. It can store as many of 8 incoming messages, and up to 45
seconds of audio. The pilot and copilot hear the playback. It is also possible to modify the unit to exclude
the copilot from the playback, and annunciation playback. Contact Bendix/King, for more details.
Recording is automatic. To play back the last recorded message, press and hold the COM Receive
pushbutton associated with the selected radio transmitter for about one (1) second. You can either wait for
the message to finish playing before accessing the prior message, or cancel the current playback and step
backward. To cancel the playback, press and hold the COM receive playback button for two seconds (2).
The next time the button is pressed for one (1) second, the next earlier message will be heard. The play-
200-890-5464
Bendix/King by Honeywell
KMA 30 Audio Panel and Intercom System
Installation and Operator's Manual
Hold button on power up Pairing Code
Nav 1
Nav 2
MKR
Page 3-11
0000 (default)
1234
1111
Rev. 1, Aug. 2012