Advertisement
SAE SR-M SERIES
Place 5/16-18 Carriage Bolt (E) into Mounting Bracket (D). Use the M6 Allen Socket Head (B) and the
M6 Nyloc Nut (C) to attach the Mounting Bracket (D) to the Housing (A). Drill a 5/16" hole into desired
mounting location. Use the 5/16": Flat Washer (F), Split Washer (G), and Nut (H) to secure the light
assembly to vehicle. Finally tighten all hardware. (See Figure below)
A - LED Light (Housing)
B - M6 Allen Socket Head (1)
C - M6 Nyloc Nut (1)
D - Mounting Bracket
SAE D-XL SERIES
Step 1
Assemble the LED Light Kit by attaching mounting bracket to the housing using the provided mount
bushings, bolts, washers and low profile nylock nuts. Place mount bushings into the housing prior to
installing mounting bracket. (See Figure Below)
10-24 Low Profile Lock Nut
1/4-20 Low Profile Lock Nut
Step 2
Mount completed LED Light Assembly using the remaining bolt, washers, and nut. Vibration Isolators
are included in the kit, but are not necessary. A 7/16" hole is required to mount the Light Assembly.
(Torque to 212 in/lbs) (See Figure Below)
Mount Bushing
1/4" Flat Washer
#10 Flat Washer
3/8" Flat Washer
3/8" Split Washer
3/8" Hex Nut
E - 5/16-18 Carriage Bolt
F - 5/16" Flat Washer
G - 5/16" Split Washer
H - 5/16-18 Nut
1/4-20 x 4.5" Socket Cap Screw
10-24 x 4.5" Socket Cap Screw
3/8" -16
Carriage
Bolt
Rubber
Shock
Isolation
Mount
Advertisement
