Black & Decker Amherst Price Pfister 49 Series Installation Instructions Manual page 3

7
7H
7 CONTROL BODY INSTALLATION
Place a bead of plumber's putty in the groove along the bottom outer edge of Plastic
Gasket (7A). Place Plastic Gasket (7A) against the bottom of Control Body (7B). From
above sink, insert Threaded Shank (7C) and Tubing (7D) through side hole of sink.
From underneath sink, place Washer (7E) and Locknut (7F) through Hose (7G). Secure Control
Body (7B) by threading Locknut (7F) onto Threaded Shank (7C). Tighten loosely, make sure
Handle (7H) swings equally in both directions. Tighten Control Body (7B) firmly to sink.
Caution: Do not over tighten!
8
8C
8B
8D
8B
8A
8A
8 HOSE ATTACHMENT
Push Quick Connect Housing (8A), firmly upward onto the Receiving Tube (8B) located
on the bottom of the Spout Body (8C), until unable to push any further. Pull down on the
Quick Connect Housing (8A). If the housing and the Inner Collet (8D) separate slightly
but do not pull off, the Receiving Tube (8B) the connection is secure.
To remove Hose (8D), push up on Quick Connect Housing (8A), holding Inner Collet
(8D) in place, pull downward on Quick Connect Housing (8A) until Receiving Tube
(8B) is free.
7B
7C
7A
7D
7E
7F
7G
8B
8A
8D
8A
ENGLISH
9
9B
9D
E
9 SOAP DISPENSER INSTALLATION
Insert Soap Dispenser Shank (9A) through Foam Gasket (9B) and into the sink holes.
[Both Control Body (9C) and Dispenser Shank (9A) can be placed in either end hole].
From underneath sink, secure Soap Dispenser Shank (9A) by screwing Plastic Locknut
(9D). Thread Bottle (9E) to Soap Dispenser Shank (9A). Hand tighten.
Caution: do not over tighten!
10
10A
10 SOAP DISPENSER HEAD INSTALLATION
Pour in liquid soap (not included) into Shank Orifice (10A). Insert Pump Mechanism
(10B) into Soap Dispenser Shank (10C). Install Dispenser Head (10D) by pushing firmly
onto Pump Mechanism (10B).
3
9A
10D
10B
10C
9C