Reversing The Door Hinge - Black & Decker BCE27 Use And Care Book Manual

Reversing the Door Hinge

1. Remove the top hinge cover screw and then remove the top hinge cover.
(see fig. # 1)
2. Using a Phillips Head Screwdriver, loosen and remove the screws holding the top
hinge in place. (see fig. # 1)
3. Remove the top hinge and carefully lift off the door.
4. Remove the screw holes plugs and door plug from the opposite side and insert the
plugs in the screw holes openings of the just removed screws. (see fig. # 2)
5. Remove the door pin from the bracket of the lower hinge by turning counter
clockwise. Move the pin to the opposite hole and tighten. (see fig. # 3)
6. Loosen the screws holding the lower hinge bracket and remove the hinge.
(see fig. # 3)
7. Remove screws on opposite side of the cabinet and align the lower hinge bracket
with holes.
8. Align the bottom hole on the left side of the door with the pin of the lower hinge
and slide into place.
fig. 2
9. Align the pin of the top hinge with top hole on the left side of the door and push
into place. Replace the screws in the upper hinge bracket but do not tighten all the
way. (see fig. # 2)
10. Make sure the door closes easily but forms a tight seal. Adjust the door as
needed. Once you are satisfied with the door alignment, completely tighten
the upper door hinge screws.
11. Replace the hinge cover, insert the screw and tighten completely. (see fig. # 2)
12. If the door does not close properly, refer to the section titled "Door Alignment".
fig. 3
screw holes plugs
lower hinge bracket
screws
door pin
English
6