AEG 97153 Instructions For Use Manual page 24

24 www.aeg-automotive.com
•
Do not run or start the vehicle while installing the
backup camera system!
•
Always follow safety instructions if the vehicle is
on jacks or a car lift or the like!
•
Caution! Risk of electrical voltage near
the spark coils, distributor cap, ignition
cables, spark plugs and
•
electrical components inside the vehicle!
•
Follow the automaker's safety instructions and
manual!
•
Only install the backup camera system in a safe
environment! Keep clothing, hair, limbs and the
backup camera system away from moving and hot
engine- and car parts!
•
During installation be sure cables are securely and
tightly mounted. Do not mount these to conduc-
tive materials. If cables are run through walls with
sharp edges (metal sheets, etc.) use ductwork or
conduit to prevent cable damage. Protect cables
from damage, do not bend. Immediately replace
damaged cables.
•
Risk of short circuits! Verify the correct polarity
when connecting the camera cable to the vehicle
power. Refer to the manual for notices and the
automaker's wiring diagram.
•
When installing the backup camera system
always be sure the safety and functionality of
other systems and equipment in the vehicle is
not impaired! Please follow the instructions of the
automaker's manual.
•
If operation system malfunctions and damage to
the backup camera system occurs during opera-
tion, immediately disconnect the equipment from
the 12 V vehicle power supply!
•
Be sure the ignition and all vehicle loads are
powered off before starting with installation of
the backup camera system!
•
12 Improper installation of the backup camera
system may damage the vehicle's electrical equip-
ment. this could result in an accident or fire.
Caution!
Risk of property damage and personal injury!
•
Even if the fuse inside the 12 V plug is tripped,
backup camera system's camera and wireless
transmitter will remain ready for use.
•
If you are unsure how to install the backup cam-
era system consult a qualified specialist or have
the system installed by a qualified specialist.
•
When removing dirt or ice and snow from the
camera lens be extremely careful so as not to
scratch it.
•
Do not wear metal body jewelry when installing
the backup camera system. Doing so could result
in a short circuit and burns!
•
Run the cables so as not to cause tripping
hazards and the cables cannot be damaged by
e.g. objects with sharp edges! Do not run cables
across hot surfaces!
The manufacturer is not responsible for damages
caused by:
•
Improper connection and / or operation.
•
Exterior force, damage to the device and / or
damage to parts of the device caused by me-
chanical impact or overload.
•
Any type of modification to the device.
•
use of the device for purposes that are not
described in this instruction manual.
•
Consequential damages caused by non-intended
and / or improper use, and / or defective batter-
ies.
•
Moisture and / or insufficient ventilation.
•
The unauthorised opening of the device.
This will void the guarantee.