Inserting/Pulling Out Of Plug-In Boards - Sony BKDS-7017 Installation Manual

4-3-2. Inserting/Pulling Out of Plug-in Boards

c
To avoid shock hazards and/or damage to the boards, be sure to turn off the power switch before inserting
or pulling out the plug-in boards.
(1) Remove the front panel. (Refer to "4-3-1. Removing and Installing of Front Panel".)
(2) Remove the five screws, the board retainer.
Removal
(3) Open the eject levers of the plug-in board in the direction of arrow 1.
(4) Pull out the plug-in board from the unit.
n
Pull out the plug-in board with a equal force for both eject levers.
Installation
(5) Insert the plug-in board along the board guide rails while putting the eject levers to 1 position as
shown in the figure.
(6) Connect the plug-in board to the connector on the mother board by putting the eject levers in the
direction of the arrow 2.
(7) Install the two board retainer in the reverse order of the steps (1) and (2).
Board retainer
BVTT3 x 5
BVTT3 × 5
DVS-7150E IM
Eject levers
Board
Board guide rail
4-3. Installation of Options for DVS-7150
To insert the board
2
1To pull out the board
4-7