Installation Guidelines - Cisco Catalyst IE3400 Heavy Duty Series Installation Manual

Switch Installation
EMC Environmental Conditions for Products Installed in the European Union
This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to EMC:
• A separate defined location under the user's control.
• Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
• AC-power distribution shall be one of the following types, where applicable: TN-S and TN-C as defined
In addition, if equipment is operated in a domestic environment, interference could occur.

Installation Guidelines

When determining where to place the switch, observe these guidelines.
Environment and Enclosure Guidelines
Review these environmental and enclosure guidelines before installation:
• This equipment is considered Group 1, Class A industrial equipment, according to IEC/CISPR Publication
Caution To meet IP67 Compliance, all cables, dust caps, or the captive screws on the SD card cover must be torqued
to the recommended spec before operating the unit. For torque specs see
Technical Specifications"
Caution Use caution when removing dust caps. Dust caps in an over-tightened state may adhere to the connector O-ring
seal. Ensure that the O-ring remains in place when dust caps are removed and follow all torque specs here:
"Cisco IE 2000 IP67 Series Switches Technical Specifications"
General Guidelines
Before installation, observe these general guidelines:
Caution
Proper ESD protection is required whenever you handle Cisco equipment. Installation and maintenance
personnel should be properly grounded by using ground straps to eliminate the risk of ESD damage to the
switch.Do not touch connectors or pins on component boards. Do not touch circuit components inside the
switch. When not in use, store the equipment in appropriate static-safe packaging.
• If you are responsible for the application of safety-related programmable electronic systems (PES), you
When determining where to place the switch, observe these guidelines:
in IEC 364-3.
11. Without appropriate precautions, there may be potential difficulties ensuring electromagnetic
compatibility in other environments due to conducted as well as radiated disturbance.
need to be aware of the safety requirements in the application of the system and be trained in using the
system.
EMC Environmental Conditions for Products Installed in the European Union
Cisco Catalyst IE3400 Heavy Duty Series Hardware Installation Guide
"Cisco IE 2000 IP67 Series Switches
11