Advertisement
By Honeywell
6. Adjust the shoulder strap and main strap tension by increasing or decreasing
the length of the loop behind the tensioners.
Tensioner
7. Launch ProRAE Guardian on your computer. Units come online automatically.
Charging The RAELink3
Before using the RAELink3, charge its Li-ion battery. For more details, consult the RAELink3 User's Guide or
Quick Reference.
Charging The BioHarness Echo Module
1. Snap the BioHarness Echo Module into the Charging Cradle and use a USB cable to connect the
Charging Cradle to a computer or the included USB charger.
2. Snap the BioHarness Echo Module into the Charging Cradle and allow it to charge. Typical
charging time for a full charge is 3 hours. A charge of 90% is typically reached in 1 hour. While
charging, the BioHarness Echo Module's orange LED flashes. When fully charged, the orange
LED glows continuously.
3. Once it is charged, remove the BioHarness Echo Module from the Charging Cradle.
Pairing The BioHarness Echo Module And The RAELink3 Via
Bluetooth
After an initial pairing of the BioHarness Echo Module with the RAELink3, the two will automatically
find each other every time they are turned on. For initial pairing, follow the instructions below.
Note: When doing initial pairing, never turn on more than one BioHarness Echo Module and one
RAELink3 at the same time.
1. Enter Programming Mode on the RAELink3 by holding the [N/-] and [MODE] keys together.
Press [N/-] twice until you see "OP Mode" (Operation Mode).
Set the mode of operation to Remote.
Set the BT (Bluetooth) to BioHarness 3.
Press [N/-] until you confirm BT (Bluetooth) power is on.
BioHarness 3
Pull tighter or add slack to change length
of strap
2
QUICK REFERENCE
Advertisement
