Honeywell Miller QuickPick Rescue Kits User Instruction Manual page 10

3. Install the QuickPick system to the anchor-
age/anchorage connector using the
attached carabiner (see Fig. 2 or 3 & Fig.
4). Always visually check that the carabi-
ner gate is completely closed and locked.
4. Open the gate of the captive-eye carabiner
with attached pigtail and install it into the
pole carabiner clip (see Fig. 5 & 6).
NOTE: When the carabi-
ner with pigtail is installed
properly, the pigtail will be
centered in the carabiner clip
as shown, so that it does not
interfere with the smooth
release of the carabiner from
the clip when the suspended
worker's back D-ring is
hooked.
5. Then connect the pigtail to the
carabiner on the lower pulley
(see Fig. 7).
NOTE: The installation of
the pigtail will help facilitate
the retrieval of the fallen
worker.
Us er I ns t r u ct ion s - En gli sh
10
Fig. 4
Auto-Locking Carabiner
Operation & Installation
1. Twist carabiner gate as
1
2. Open gate inward and
3. Release the gate making
2
WARNING! The carabiner must be installed
in such a way that the opening action cannot
be duplicated by contact made with an object
it is connected to or has the potential to come
in contact with. Make sure that the carabiner
is positioned so that its gate is never load
bearing.
Fig. 6
shown.
make connection within the
rescue system as required.
sure that it closes com-
pletely and locks.
L-BLACK Rev. 8-10
L-BLACK Rev. 8-10
Fig. 5
Fig. 7
HEAVY DUTY
SERVICIO SEVERO
SERVICE INTENSIF
HEAVY DUTY
ALUMIGLASS
SERVICIO SEVERO
®