Audio Control; Time-Out Timer (Tot); Tot Pre-Alert; Tot Rekey Time - Kenwood TK-3180 Function Reference

16.1.6 Audio Control

This function allows you to configure the conditions to
disable the Mute function using the QT/DQT and Option
Signaling. (Refer to 18.3 Signaling (Audio Control).)
You can configure the Audio Control function using KPG-
89D. You can configure the function to each Zone.
!
Configuration using KPG-89D
•
Configuring the Audio Control (Refer to FPRG
6.2.6 Audio Control.)

16.1.7 Time-out Timer (TOT)

This function limits the continuous transmission time
(TOT). (Refer to 11 Time-out Timer.)
You can configure this period using KPG-89D.
!
Configuration using KPG-89D
• Configuring the Time-out Timer (TOT) (Refer to
FPRG 6.2.7 Time-out Timer (TOT).)

16.1.8 TOT Pre-alert

This function allows you to notify a user that the Time-out
timer is about to expire.
You can configure the timing to emit the TOT Pre-alert
tone using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the TOT Pre-alert (Refer to FPRG
6.2.8 TOT Pre-alert.)

16.1.9 TOT Rekey Time

The function is used to configure the duration of the time
from the time when the Time-out Timer starts operating to
the time when the transceiver starts transmitting again.
(Refer to 11.1.3 TOT Rekey Time.)
You can configure the TOT Rekey Time using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the TOT Rekey Time (Refer to FPRG
6.2.9 TOT Rekey Time.)
Version: 1.11
(Refer to 11.1.2 TOT Pre-alert.)

16.1.10 TOT Reset Time

The TOT Reset Time is the function to reset the Time-out
Timer. (Refer to 11.1.4 TOT Reset Time.)
You can configure the TOT Reset Time using KPG-89D.
!
Configuration using KPG-89D
• Configuring the TOT Reset Time (Refer to FPRG
6.2.10 TOT Reset Time.)

16.1.11 BCL Override

This function allows the transceiver to transmit data while
the transceiver channel is busy, even if the transceiver do
not normally transmit on a busy channel.
BCL Override.)
You can enable/disable this function using KPG-89D.
!
Configuration using KPG-89D
• Configuring the BCL Override function (Refer to
FPRG 6.2.11 BCL Override.)

16.1.12 Zone Add

You can configure the Zone to be added to the Scan List
using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the Zone Add function (Refer to FPRG
6.2.12 Zone Add.)

16.1.13 Scan List

You can configure the Scan List according to the
configuration of the Scan List Table using KPG-89D.
!
Configuration using KPG-89D
• Configuring the Scan List (Refer to FPRG 6.2.13
Scan List and FPRG 6.2.15 Scan List Table
window.)
Function Reference
16 CONVENTIONAL GROUP
(Refer to 12.2
53