Table of Contents
Advertisement
REMOTE CONTROL FUNCTIONS
TEMPERATURE MEASUREMENT
This function measures the ambient temperature at the lower part of the handheld transmitter which is then shown in
the display. This depends on the location of the handheld transmitter and may therefore deviate from the actual room
temperature. The deviation can be offset by setting the temperature offset function (-8 to +8°). The factory setting for
the temperature display is °C.
Settings
Login
Language
Temperature
Histogram
EnOcean service
Remote management
2.00
l
D - 16
Set temperature offset and display
l
Temperature
Cancel without changing: ....................................................
Offset
0.0 K
Confirm and back (to Settings): ...........................................
Display
° C
Offset setting (-8 to +8°) / display (C° or F°): ....................... ,
21.5°C
Select: .................................................................................. ,
Temperature offset setting:
• Wait for the temperature display to stabilise (approx. 60 mins).
• Measure room temperature with an accurate thermometer.
• In the event of a deviation between the temperature display and room temperature,
adjust the temperature offset to correct the deviation.
Factory setting: Offset = 0° , °C
Important note!! The accuracy of the temperature measurement is heavily dependent on
the point of use! If the handheld transmitter is influenced by a heat source (e.g. heating,
sun, etc.), this will affect the precise temperature measurement and heating regulation!
Temperature measurement is also affected after charging the batteries!
PEHA_M_450FU_HS128 (Rev02-26.07.17)
Advertisement
Table of Contents
