Breville HotCup VKT111 Instruction Booklet page 4

using your HotCup
Before using your HotCup
• Remove your HotCup
packaging and promotional material and position it on a dry, level, secure work
surface away from the edge.
• Make sure that the re-set button at the rear of the appliance is pressed in.
• Follow the instructions below on using your HotCup
first full tank of boiled water by cycling the appliance. This will remove any residues
that may remain from the manufacturing process.
Using your HotCup
Always position your HotCup
button cannot be accidentally operated especially by children.
If water has been left in your HotCup
the water reservoir to the MAX marking and discard all of the water by cycling the
appliance as described below.
1. Lift the lid. Fill the water reservoir with cold water using a suitable jug. The water level
should be between the MIN and MAX markings.
2. Close the lid, then plug your HotCup
3. Position the drip tray according to the height of your cup:
• For a tall cup, place the drip tray in the lower position by guiding it onto the
magnetised plate on the HotCup
• For a shorter cup, turn the drip tray upside down and hook the lip of the tray into
the positioning slot. The magnet will guide the drip tray into the correct position.
4. Place the drip tray inner and the stainless steel drip tray cover onto the drip tray.
5. Position your cup with a tea bag, coffee, sugar, etc. below the dispensing nozzle.
Never operate your HotCup
placed below the dispensing nozzle.
6. Turn the dispensing control to the required setting. The control adjusts the quantity
of boiling water dispensed by your HotCup
teacups, set the control towards the
the control towards the
use a lower setting until you gain experience using your HotCup
7. Press the start button. The water reservoir, dispensing nozzle, and the window under
the stop button will light up. If the start button doesn't start the appliance, check that
the re-set button at the rear of the appliance is pressed in.
8. The selected quantity of boiling water will be dispensed into the cup and then stop.
Alternatively, press the stop button to only dispense the amount of water you require.
Always keep your HotCup
MAX markings). That way you'll ensure that it's always ready to use and don't forget,
unlike an ordinary kettle, this will have no effect on the energy your HotCup
dispenser uses.
4
water dispenser
™
water dispenser for the first time
™
water dispenser carefully from the box. Remove any
™
water dispenser
™
water dispenser in such a way that the start
™
water dispenser for a number of days, fill
™
water dispenser into a mains supply socket.
™
water dispenser until secured in place.
™
water dispenser without a cup or suitable container
™
setting; for larger cups like coffee mugs, set
setting. If you are not sure which setting to use, it's best to
water dispenser topped up with water (between the MIN and
™
water dispenser and discard the
™
water dispenser. For smaller cups like
™
water dispenser.
™
water
™