Power Failure (Ac Power); Installing Power Cord Retainer - D-Link DGS-1250 Series Hardware Installation Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide

Power Failure (AC Power)

In the event of a power failure, just as a precaution, unplug the power cord from the Switch. Afterthe power returns,
plug the power cord back into the power socket of the Switch.

Installing Power Cord Retainer

To prevent accidental removal of the AC power cord, it is recommended to install the power cord retainer together with
the power cord.
1. With the rough side facing down, insert the tie wrap into the hole below the power socket.
2. Plug the AC power cord into the power socket of the Switch.
Figure 2-5 Insert Tie Wrap into the Switch
Figure 2-6 Connect the power cord to the Switch
16