Installing Transceivers Into The Transceiver Ports; Power On (Ac Power) - D-Link DGS-1250 Series Hardware Installation Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide

Installing Transceivers into the Transceiver Ports

The Switch is equipped with Small Form-factor Pluggable (SFP) and Enhanced Small Form-factor Pluggable (SFP+)
ports that can be used to connect various other networking devices to this switch that do not support the standard
RJ45 wiring connection. These ports are generally used to connect this switch to optical fiber connections and can be
used to connect devices to the Switch over great distances. The maximum distance that the RJ45 wiring connection
can reach is 100 meters. Fiber optic connections can span several kilometers.
The figure below illustrates how to properly insert SFP/SFP+ transceivers into the Switch's SFP/SFP+ ports.
The SFP/SFP+ ports also support other transceiver form factors like SFP and SFP+ transceivers. A complete list of
SFP/SFP+ transceivers, compatible with this switch, can be found in the SFP+/SFP Ports section in Appendix A -
Technical Specifications at the end of this document.
NOTE: Only use pluggable optical modules and Direct-Attach Cables (DAC) that meet the following
regulatory requirements:
•
•
•
•

Power On (AC Power)

Plug one end of the AC power cord into the power socket of the Switch and the other end into the local power source
outlet. After the system is powered on, the LED will blink green to indicate that the system is booting up.
Figure 2-4 Inserting transceivers into the transceiver ports
Class 1 Laser Product
UL and/or CSA registered component for North America
FCC 21 CFR Chapter 1, Sub-chapter J in accordance with FDA & CDRH requirements
IEC/EN 60825-1/-2: 2007 2nd edition or later, European Standard
15