Advertisement
•
Connect the faucet inlet tubes (Q) to inlet supply lines (R). Connect the
supply stops (S) to the inlet supply lines (R) (left is hot water supply and
right is cold water supply). Make sure inlet supply lines (R) are securely
tighten. Do not over- tighten.
•
Turn on water. Check for any leaks. Make sure all the connections are
secure.
•
Remove aerator (T).
•
Open the handle.
•
Flush and allow water to run at full flow for at least one minute.
•
Replace aerator (T).
Main Supply Connection
7
REV-01 14, 13
Advertisement
