Brother DCP-L8400CDN Service Manual page 254

Assembling Note:
Since the Second side CIS flat cable might be broken when you remove it from the Flat
cable holder, be sure to replace it with a new Second side CIS flat cable.
When assembling a new Second side CIS flat cable, be sure to assemble it in accordance
with the following procedure.
<Assembling procedure>
(1) Fold the Second side CIS flat cable at the Second side CIS unit side as shown in the
how-to-fold figure below.
■
A4 model
Fold down
Fold back
Supporting tape
■
Legal model
Fold down
Fold back
Supporting tape
Surface of the Supporting plate
(Back side: Terminal surface)
Second side CIS flat cable
200±2 mm
Fig. 3-102
Surface of the Supporting plate
(Back side: Terminal surface)
Second side CIS flat cable
210±2 mm
Fig. 3-103
3-90
<To be connected to
Second side CIS unit>
<To be connected to
Second side CIS unit>
Confidential