Key Setup (Key Menu) - Sony MKS-2010 User Manual

Command name Function of command button
Rec When pressed together with the Play button, execute
recording on the selected device.
Shuttle Turn shuttle mode on or off.
Jog Turn jog mode on or off.
PVW Select M/E Switch Edit PVW output to M/E PVW output. (Goes off
automatically when other operation disables this command.)
PVW Select PST Switch Edit PVW output to PST output. (Goes off
automatically when other operation disables this command.)
Auto PVW Turn auto preview on and off. When auto preview is on, Edit
PVW output switches as follows.
Button with PVW Select M/E assignment is on: If M/E
PGM is on-air, switch Edit PVW output to M/E PVW
output. If M/E PGM is not on-air, switch Edit PVW output
to M/E PGM output.
Button with PVW Select PST assignment is on: If M/E
PGM is selected on both PGM bus and PST bus, switch
Edit PVW output to M/E PVW output. If signal other than
M/E PGM is selected on either PGM bus or PST bus,
switch Edit PVW output to PST output.
a) Unless otherwise specified, lit in amber
b) [?] is the GPI number selected in step 5 of "Assigning utility commands" (see page 170).

Key Setup (Key Menu)

Use the Key menu to make settings related to keys, such as
key memory and the show key function.
Selecting the key memory operating mode
See "Using Key Memory" (page 110), for more
information about key memory.
1
From the top menu, select Setup/Diag >Operation
>Key.
The Key menu appears. The current key and key
memory operating mode, key bus cross-point hold
mode, and mask/border processing order settings
appear in the status area.
2
Using any of the following methods, select the target
key.
Button state
a)
Lit
Lights in red during
execution.
On
On (lit in green)
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
Knob Description
1 (Key) Key selection
a) 1: Key1, 2
2: DSK1, 2 (1.5 M/E panel only)
3
Press [Key Memory].
A popup window appears.
4
Select the key memory operating mode.
• Simple
• Full
• Off
Setting the key bus cross-point hold mode
You can set the operating mode of the key bus [XP/KY
HOLD] button in the AUX bus control block.
1
Carry out steps 1 and 2 of "Selecting the key memory
operating mode".
2
Press [XP/KY Hold].
A popup window appears.
3
Select the cross-point hold mode.
Not lit
Recording over or
stopped
Off
Off
Setting values
a)
1, 2
173
Other Settings