Guide To Replacement - Canon FAX-L260i Service Manual

5. GUIDE TO REPLACEMENT

See Page
FIGURE 2-a
2-2
1
2
1
1
1
2
3
To remove the left and right side covers, use a fine
screwdriver or your finger to unhook the retaining
clips.
See Page
FIGURE 4-a
2-4
TONER SENSOR CABLE
bundle
Route the TONER SENSOR CABLE as shown in
the figure to anchor the LASER CABLE and DOOR
SENSOR CABLE.
See Page
FIGURE 2-b
2-2
While pressing either the left or right side cover in
the direction shown, lift off the upper cover.
See Page
FIGURE 4-b
2-4
PLUG,SHORT
The service part version of the SCNT board has a
SHORT PLUG on one of the pins.When replacing
the SCNT board, cover both pins with the plug. If
both pins of the SCNT board service part are already
by the plug, DO NOT INSTALL THE PART; the
backup battery may be significantly depleted. When
installing, be careful to avoid electrostatic damage
to board components.
See Page
FIGURE 3-a
2-3
When removing the READING ASS'Y, use one hand
to support, the READING ASS'Y while removing
the TAPER PIN.
See Page
FIGURE 4-c
2-4
Be careful not to apply
too much pressure
When exchanging the ROM on the G4 board, please
work on a table or stand which has an electrically
resistant rubber mat. When removing the ROM, first
remove the G4 board from the machine, and then
use the special tool (part No.HY9-0022-000) to
remove the ROM. Also, when attaching the ROM to
the G4 board, if the ROM is pressed into place from
the top too firmly, the patterns or elements on the
board may be damaged, so please be careful.
See Page
FIGURE 3-b
2-3
Use a FLAT CABLE to gather and contain the cables
coming from the READ ASS'Y.
See Page
FIGURE 5-a
2-5
2
1
To attach the WATER PROOF COVER to the PCNT
board, slide it into position (1) and press down to
secure (2).
FAX-L260i 5.GUIDE TO REPLACEMENT 5-1