Sony ZS-2000 Primary Operating Instructions Manual page 15

On the remote
1 Press BAND to select
the band.
2 Press TUNE + or – to
set the frequency to
the station you want.
3 Press and hold the
number button that
you want to preset
the new station on
for 2 seconds.
If a station cannot be preset automatically
You need to preset a station with a weak signal
manually. You can also label the preset station.
1 Press RADIO BAND•AUTO PRESET to select the
band.
2 Tune in a station you want.
3 Hold down DISPLAY•ENTER MEM for 2 seconds
until the preset number flashes in the display.
4 Press PRESET + or – until the preset number (1 to
10) you want for the station flashes in the display.
5 Press DISPLAY•ENTER MEM.
6 Input the name of the station (up to 8 characters).
1 Select a character by pressing TEXT + or –.
2 Press CURSOR t to make the cursor shift
rightward.
Repeat steps 1 and 2.
You can also use the following buttons:
Button to use
CURSOR T, t
CHARACTER
7 Press DISPLAY•ENTER MEM.
Function
Move the cursor leftward or
rightward
Each time you press the button, the
character changes as follows:
Upper case letters t
Lower case letters t
Numbers and symbols.
15
The Radio