Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Armature (cont.)
DISASSEMBLING
(2) Disassemble the parts in bottom section and remove Armature from Motor housing as drawn in Fig. 2.
Fig. 2
1. Remove Pad complete
by unscrewing four
M4x10 +Pan head screws.
Pad complete
4. After removing Flat washer 6,
Base is removed together with
Ball bearing 6001ZZ.
Flat washer 6
Ball bearing
Base
6001ZZ
7. Remove four 4x18 Tapping screws that
fasten Bearing box to Motor housing.
4x18 Tapping
screws
2. Remove Cap 28 by levering
up with slotted screwdriver.
Cap 28
5. Remove Sponge sleeves and Foots
with O rings 4 from Bearing box.
O ring 4 (8 pcs.)
Foot
(4 pcs.)
Sponge
sleeve
(4 pcs.)
Bearing box
Caution:
Sponge sleeves, Foots and O rings may be left to Base.
Be careful not to lose them when Base is turned upside down.
8. Disassemble Armature assembly and Bearing box from
Motor housing by tapping the skirt portion of Motor
housing with plastic hammer.
3. While holding Fan 65 by inserting slotted
screwdriver from
the gap between Motor
housing and Base, remove M4x10
+Countersunk head screw.
M4x10 +Countersunk
head screw
Base
Motor
housing
Slotted
screwdriver
6. Remove Fan 65 from Armature
shaft.
Fan 65
P 3/ 7
Advertisement
