Channel Setting - Sony WRR-801A Operating Instructions Manual

Channel Setting

Connections
Take the following precautions to prevent interference
and noise.
• Do not simultaneously use two or more microphones
and transmitters that are set to the same channel.
• When simultaneously using two or more tuners,
always set the tuners to different channels within the
same group (other than group 00).
• Separate the reception antennas and the transmitter by
more than 3 meters (9 feet 11 inches).
1
ON
OFF
POWER
1
Turn the POWER switch on.
The message "AS 66" appears on the display, and
then the current tuner status is displayed.
Note
Turn the POWER switch on after reducing the
volume of equipment connected to the TUNER
OUTPUT connector. Otherwise, noise will be
heard when the power is turned on.
2
Press and hold down the SET button, and press the
GP button in 3 seconds to select a group.
Each time you press the GP button, the GP
indication changes as shown in the following
figure. To change the indication continuously,
press and hold down the GP button.
GP CH
12
2
1
BATT
GP
AF BATT
RF
SET CH
GP CH
2,3 3
GP CH
The CH indication shows the lowest frequency
channel of the selected group. For group 00,
however, the channel selected last is displayed.
Releasing the buttons automatically cancels the
group and channel selection mode, and the
currently displayed group is selected.
3
Press and hold down the SET button, and press the
CH button in 3 seconds to select a channel.
Similar to step 2, each time you press the CH
button, the CH indication changes in the order
shown in the group and reception channel list. (See
"Wireless Channel Lists" on page 6.)
If you press the CH button when the last channel
of the selected group is displayed, the first channel
of the group will be displayed.
GP CH
Selecting the reception channel by frequency
Press the GP button.
This changes the GP/CH indication to a frequency
indication.
To change a frequency, press the CH button while
keeping the SET button pressed. (A higher
frequency will be displayed.)
Press the GP button again to change the frequency
indication to a GP/CH indication.
GP CH
4
If the desired channel or frequency is displayed,
release the SET button and CH button.
The selected channel is set.
To store the selected group and channel
Leave the indication unchanged for 5 seconds.
The group and channel set in the procedure explained
above are stored in memory.
GP CH
GP CH