English
2
1
Using the invisible wall FC8822
2
1
Removing the dry wipe attachment
Remove the dry wipe attachment as soon as you have finished wiping
the floor.
Turn the robot upside down and place it on the floor or on a table.
Push one end of the dry wipe attachment towards the wheel on the
other side of the robot to release it. Then pull the attachment off the
robot.
Placing the batteries in the invisible wall
The invisible wall operates on four AA batteries.
Push the two release tabs at the bottom of the back cover
the back cover upwards and off the invisible wall
Take four new AA batteries from the pack and insert them into the
battery compartment of the invisible wall.
Note: Make sure the + and - poles of the batteries point in the right
direction.
Slide the back cover onto the invisible wall again.
and slide
.