Installing And Connecting The Tv; Unpacking; Inserting Batteries Into The Remote Control; Connector Types - Sony WEGA KLV 21SR2 Operating Instructions Manual

Installing and Connecting the TV

Installing and
Connecting the
TV

Unpacking

When you unpack this unit, make sure it includes the
following:
Remote control (1) and
size AA batteries (2)
75-ohm coaxial cable (1)
Operating Instructions
Warranty Card
Product Registration
Inserting Batteries into
the Remote Control
Insert two size AA batteries (supplied) by matching
the + and – on the batteries to the diagram inside the
remote control's battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery
leakage whenever you anticipate that the remote control will
not be used for an extended period.
• Handle the remote control with care. Avoid dropping it,
getting it wet, or placing it in direct sunlight, near a heater or
where the humidity is high.
• Your remote control can be programmed to operate most video
equipment (See "Operating Video Equipment with Your TV
Remote Control" on page 30).
6
AC power cord (1)

Connector Types

You may find it necessary to use some of the
following connector types during set up.
Supplied 75-ohm coaxial cable
Screw-on type
Screw into connection.
S VIDEO cable
High quality video cable for enhanced picture quality
Align guides and push into
connection.
AUDIO/VIDEO cable
Push into connection.
VIDEO - Yellow
AUDIO (Left) - White
AUDIO (Right) - Red
Some DVD players are equipped with the following
three video connectors:
Y - Green
P (C , C or B-Y) - Blue
B B b
P (C , C or R-Y) - Red
R R r