Section 3: Setup; Dust Collection; Test Run - Grizzly T1188 Owner's Manual

Inventory
Model T1188 Inventory (Figure 3)
A. Trim Router (Not Shown) . ................. 1
B. Collet Wrench 22mm ......................... 1
C. Collet Wrench 13mm ......................... 1
D.
⁄ " Roundover Bit ............................... 1
1
4
E. Edging Tool ........................................ 1
B
C
D
Figure 3. Model T1188 inventory.

Test Run

Once assembly is complete, test run trim
router to ensure it is properly connect-
ed to power and safety components are
functioning.
If you find an unusual problem during
the test run, immediately stop the router,
disconnect it from power, and fix the
problem BEFORE operating it again. The
Troubleshooting table in the SERVICE
section of this manual can help.
Serious injury or death can result
from using this tool BEFORE under-
standing its controls and related
safety information. DO NOT operate,
or allow others to operate, router
until information is understood.
Model T1188 Edgebanding Trim Router

SECTION 3: SETUP

E
To test run trim router:
1. Clear all setup tools away from trim
tool.
2. Connect tool to power supply.
3. Turn tool ON, verify motor operation,
and then turn tool OFF.
The motor should run smoothly and
without unusual problems or noises.

Dust Collection

This tool is equipped with a 1" outside
diameter dust port (see Figure 4). Connect
a shop vacuum hose to the dust port.
1" Dust
Port
Figure 4. Dust port location.
DO NOT operate tool without prop-
erly connecting dust collection,
or material may build up inside
dust hood, resulting in clogging,
malfunction, or other unexpected
results.
Dust
Hood
-7
-