Commissioning; I1 Preliminary Checks, Adjustments And Operational Tests; I1.1 Electrical And Plumbing Checks; I1.2 Fitting Of Filters, Overflow And Wash Arms Check - Electrolux EGWSSIC Manual

I
I1 Preliminary checks, adjustments and
operational tests
I1.1 Electrical and plumbing checks
Before starting the machine, it is necessary to:
• check the correct connection of the electrical wires
powering the machine;
• make sure the power supply voltage and frequency
match the data given in Table 2;
• check the correct connection of the water supply
and discharge pipes;
• make sure all the guard and safety devices are in
place and efficient.
I1.2 Fitting of filters, overflow and wash arms
check
Make sure the overflow "1", the tank filter "2" (depend-
ing on the model), the upper and lower wash arms "3
and the upper and lower rinse arms 4" are correctly fit-
ted (Figure 10).
3
3
4
2
1
Figure 10 Tank filter, overflow, washer and rinse
I2

Commissioning

• Turn on the water supply tap.
• Activate the main switch ahead of the machine by
turning it to "I".
• Press the ON/OFF button ("A" - Table 3 "Control
panel").
18
COMMISSIONING
4
arms
I3 Detergent/rinse aid dispensers and
prearrangements
If the machine is connected to a water softener and/or
a reverse osmosis system, contact the detergent sup-
plier for a specific product.
If the peristaltic dispensers are installed in the
machine, the dosage of detergent/rinse aid is done
automatically according to the desired concentration.
The concentration of detergent/rinse aid depends on
the type of product used and the hardness of the sup-
ply water (check the characteristics on the product
label).
ATTENTION ATTENTION
The peristaltic dispensers (detergent) and the tube
inside the rinse aid dispenser require periodical
maintenance (at least once or twice a year) or after
prolonged machine idle periods.
I3.1 Dishwasher with incorporated rinse aid
dispenser (Figure 11)
To vary the dose, adjust the screw "D"
required (Figure 11).
To check the efficiency of the rinse aid look at a freshly
washed glass. Drops of water on the glass indicate an
insufficient dosage while streaks indicate an excessive
dosage which can either be caused by the density or
the quantity.
Figure 11 Rinse-aid dispenser
Info
Upon first installation, it may be necessary to activate
the dispenser in the following way:
• press the screw in until the rinse-aid has filled the
tube.
I3.2 Dishwasher with incorporated detergent
dispenser.
Depending on the model.
Adjust the screw "L" to set the required dose (Figure 11).
The adjustment of the amount of detergent delivered
by the pump must carefully comply with that indicated
by the detergent producer.
This quantity is usually expressed in g./l and various
depending on the water hardness.
as