Makita RP1110C Technical Information page 2

R
epair
< 1 > Repairing armature
(1) Remove router bit, collet nut and stopper pole.
(2) Remove knob (without switch trigger, lock off/on button) by turning it anti-clockwise.
Compression spring 8 is to be removed automatically together with the knob.
Also lock pin has to be taken off from the threaded hole for knob. See Fig.1.
Compression spring 8
Knob
(3) Separate motor section from base section after taking off wing nut M10 and nylon nut M10.
Wing nut M10
(4) Take off brush holder cap and carbon brush.
(5) Remove knob cover R by taking off 2 pcs. of tapping screw 4x18.
Pay attention, not to lose compression spring which may spring out from the knob,
when removing the knob cover.
(6) Take off lock off button, trigger and switch from the knob R.
(7) Remove knob R from motor section by taking off pan head screw M6x20
as illustrated in Fig.3.
Carbon brush 50
40
30
20
10
0
Brush holder cap
Wing nut M10
Nylon nut M10
Lock pin
Nylon nut M10
Motor section
Compression spring 7
Knob
Motor section
50
40
30
20
10
Knob R
0
Collet nut
Base section
Brush holder cap
50
40
30
20
10
0
Base section
Switch
Pan head
screw M6x20
P 2 / 6
Fig.1
Fig.2
Lock off button
Compression spring 8
Trigger
Knob cover R
Tapping screw 4x18
Fig.3