Huawei SmartLogger1000 User Manual page 216

SmartLogger1000
User Manual
Figure 7-25 EMI

Parameter
EMI model
Synchronize Environment
Data
Master/Slave

Parameter
EMI model
Synchronize Environment
Data
Master/Slave
Read function code
Data reporting mode
Issue 12 (2019-01-15)
When the connected device model is in the EMI model drop-down list, set the
parameters as follows.
If the connected EMI is a split-type one that supports the Modbus-RTU protocol, set the
parameters as follows.
Copyright © Huawei Technologies Co., Ltd.
Description
Set this parameter to the model of the corresponding EMI.
Currently, the following models are supported: ABB
VSN800-12, ABB VSN800-14, Gill MetPak Pro, Hukseflux
SRx, Ingenieurbü ro Si-RS485TC, Kipp&Zonen SMPx, Lufft
WSx-UMB, Lufft WSx-UMB (external sensors), Meier-NT
ADL-SR, Meteo control SR20-D2, Rainwise PVmet-150,
Rainwise PVmet-200, Soluzione Solare SunMeter, JinZhou
LiCheng, JinZhou YangGuang (PC-4), and HanDan
(RYQ-3).
Retain the default value Disable.
NOTE
If Enable is selected, wind speed and direction will be sent to the
inverters in a PV plant with the tracking system.
When the SmartLogger connects to multiple EMIs, you can
set one of them to master mode. The inverter performance
data contains that of the EMI in master mode.
Description
Set this parameter to Sensor(ADAM).
Retain the default value Disable.
NOTE
If Enable is selected, wind speed and direction will be sent to the
inverters in a PV plant with the tracking system.
When the SmartLogger connects to multiple EMIs, you can
set one of them to master mode. The inverter performance
data is that of the EMI in master mode.
Read holding register 03H and Read input register 04H
are supported. Set this parameter based on the vendor's
protocol.
Integer and Floating point are supported. Set this parameter
based on the vendor's protocol.
7 WebUI
203