Honeywell TH8321 Product Data page 47

cold outdoor temperatures, poorly insulated windows
require a lower Window Protection setting, which will
limit how much your humidifier can run.
7. After you set the Window Protection setting, check for
frost/condensation on your windows in the morning.
If frost/condensation is present, adjust the Window
Protection setting to the next lowest number and
check for frost/condensation on your windows the
next morning. Continue to adjust the Window Protec-
tion setting to a lower number until frost/condensa-
tion is no longer present.
NOTE: Window Protection is available only if connected
to an outdoor wired sensor or to the Internet.
NOTE: The thermostat controls humidification and dehu-
midification as needed to maintain the desired
humidity level. Depending on how your thermostat
was installed, the thermostat may maintain a 15%
separation between humidification and dehumidi-
fication settings.
Adjusting Dehumidification
Settings: Residential Use
This feature can control a dehumidifier or use your air
conditioner to reduce humidity.
1. Touch MENU and select Dehumidification.
Fig. 70.
2. Select Auto.
3. Touch
MCR34100
4. Touch Done to save your settings. Touch Cancel to
NOTE: If your air conditioner is used to control humidity,
47
VISIONPRO® 8000 SMART THERMOSTAT
Dehumidification
Equipment Status
Fig. 71.
Dehumidification
Off Auto
Fig. 72.
 
or to select humidity level.
ignore changes.
the temperature may drop up to 3° F below your
temperature setting until humidity reaches the
desired level.
MCR34130
MCR34131
33-00096—04