Warning - Panasonic LP-400 Series External Control Manual

Warning

Errors that notify of that the setting data are incorrect or laser radiation conditions are not met are output as warnings.
Marking operation cannot be started while any warning is active. Laser pumping maintains the state before the warning.
Release method of warning
1) Remove a cause of warning. If the warning cause is the wrong setting, correct the file data.
2) When the laser marker is under the remote mode, close the shutter by I/O or serial communication control.
In case of the following warning, the shutter control is unnecessary.
• E800: the warning occurs only while the specified one-shot output time and it is released automatically.
• E811: the warning occurs only during the laser stop is opened, and then it is released automatically when the laser
stop is closed.
3) If the warning occurs during the marking operation of the files in which the counter function is set, check if the counter
value is correct before restart the marking operation.
4) In case that marking is executed again, make sure that the warning output is turned on, and then open the internal
shutter.
ERROR
CODE
Detected a decrease in clock battery voltage. Reset
E251
present time.
There is not enough free space.
E500
The file cannot be registered.
E501 Cannot register setting because of memory error.
E502
Invalid file format of font or logo file.
E503
E600 No setting file.
E601 No font file.
E602 Lack of font memory.
E603 No logo file.
E604 Included character not registered into font file.
Exceed valid number of characters.
E605
(Max. 30 characters/line.)
154
Error details
ME-LP400V-EX-6
Measures
Contact to our sales office.
While laser Marker power is on, reset "Present Time"
in Environment Setting. When the power is off, reset
"Present Time".
Delete registered file and logo file.
• Restart with key switch.
• When not recovered, contact our sales office.
• Register the logo or font file again on the USB
screen.
• For the logo file, convert the logo data to VEC
format again with Logo data conversion software.
Set the marking data such as character, barcode and
logo.
• Register font file.
• Set a registered font to the font in character
condition.
Make font file smaller, or delete unnecessary font file.
Register logo file.
Change characters.
Or set the font file containing the setting characters.
Make numbers of characters smaller.