Epson RC620 Manual page 73

3. Connect the board with the Fieldbus.
4. Start up the controller.
5. The PROFIBUS-DP master board is detected and the [Found New hardware Wizard]
6. The following dialog box appears.
7. Select <Install the software automatically (Recommended)>.
8. Click <Next>.
RC620 Option Fieldbus I/O Rev.8
2-4 Put two screws removed in the step 2-2 back and secure them.
2-5 Put the top plate back and secure it with ten screws.
dialog box appears.
Select <No, not this time> and click <Next>.
Confirm that the detected hardware is "applicomIO PCI Board 32K".
(6)
(7)
(8)
2. Installation
63