Troubleshooting; Specifications - Sony CDP-XE570 Operating Instructions Manual

Troubleshooting

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.
There's no sound.
• Check that the player is connected securely.
• Make sure you operate the amplifier correctly.
• Adjust the analog output level with ANALOG
OUT LEVEL +/– on the remote (CDP-XE570/
XE370 only).
The CD does not play.
• There's no CD inside the player. "– NO DISC –"
(or "no dISC" for the CDP-XE370/XE270)
appears. Insert a CD.
• Place the CD with the label side up on the disc
tray correctly.
• Clean the CD (see page 17).
• Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour.
The recording level has changed.
• The recording level changes if you adjust the
analog output level with ANALOG OUT
LEVEL +/– on the remote during recording
(CDP-XE570/XE370 only).
The remote does not function
(CDP-XE570/XE370 only).
• Remove the obstacles in the path of the remote
and the player.
• Point the remote at the remote sensor
player.
• Replace all the batteries in the remote with new
ones if they are weak.
18

Specifications

Compact disc player
Laser
Frequency response
Dynamic range
Harmonic distortion
Outputs
ANALOG
OUT
DIGITAL
OUT
(OPTICAL)
PHONES
(CDP-XE570
only)
General
Power requirements
Where purchased
USA
Europe
Australia
Some Asian
countries
on the
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1) (CDP-XE570/
XE370 only)
R6 (size AA) batteries (2) (CDP-XE570/XE370 only)
Design and specifications are subject to change
without notice.
Semiconductor laser (λ =
780 nm)
Emission duration:
continuous
2 Hz to 20 kHz ± 0.5 dB
More than 93 dB
0.0045%
Jack Maximum
type output level
Phono 2 V
jacks (at 50
kilohms)
Optical –18 dBm
output
connector
Stereo 10 mW
phone
jack
Power requirements
120 V AC, 60 Hz
230 V AC, 50/60 Hz
240 V AC, 50/60 Hz
220 V– 230 V AC, 50/60 Hz
11 W
430 x 95 x 290 mm
(17 x 3 3/4 x 11 1/2 in.)
incl. projecting parts
CDP-XE570: 3.3 kg (7 lbs
5 oz)
CDP-XE370: 3.2 kg (7 lbs
1 oz)
CDP-XE270: 3.2 kg (7 lbs
1 oz)
Load
impedance
Over 10
kilohms
Wave length:
660 nm
32 ohms