Getting Started - Sony CDP-XA30ES Operating Instructions Manual

What cords will I need?
pWhen making analog hookups
Audio cord (supplied) (1)
White
(L)
Red
(R)
pWhen making digital hookups
Optical cable POC-15 (not supplied)
Coaxial cable (not supplied)
Hookups
pWhen making analog hookups
When connecting an audio cord, be sure to match the
colour-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
LINE OUT
FIXED VARIABLE
L L
R R
• If you have an analog power amplifier
Connect the amplifier via the VARIABLE LINE OUT jacks
using the supplied audio cord. You can adjust the output
level with the LINE OUT/PHONE LEVEL control on the
player or the LINE OUT LEVEL buttons on the remote.
CD player
LINE OUT
FIXED VARIABLE
L L
R R
pWhen making digital hookups
You can avoid deterioration of the signal during
transmission, since the music signal output through
the digital output connectors retains digital form.
You can connect a digital component such as a
digital amplifier, D/A converter, DAT or MD. When
you connect a DAT or MD, you can make digital
recordings from CDs.
Note that you cannot use fading in or out function
(page 19) when making this connection.
• If you have a digital component with an optical digital
input connector
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
White
(L)
Red
(R)
• If you have a digital component with a coaxial digital
input connector
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
Amplifier
INPUT
CD
Note
When you connect via the DIGITAL OUT connector, noise
L
may occur when you play CD software other than music, such
R
as a CD-ROM.
Setting the voltage selector (voltage
selector equipped models only)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
Amplifier
before connecting the mains lead to a wall outlet.
INPUT
CD
L
R
Connecting the mains lead
Connect the mains lead to a wall outlet.
Removing the notice sheet
The notice sheet is put on the player. Remove the sheet
before you use your player.

Getting Started

CD player Digital component
DIGITAL OUT
DIGITAL IN
OPTICAL COAXIAL
OPTICAL
CD player Digital component
DIGITAL OUT
DIGITAL IN
OPTICAL COAXIAL
COAXIAL
110 - 120 V 220 - 240 V
EN
5