Table of Contents
Advertisement
Cisco Single-Port Antenna Stand for Multiband TNC Male-Terminated Portable Antenna (Cisco 3G-AE015-R)
Technical Specifications
The following table lists the technical specifications for the Cisco 3G-AE015-R antenna.
Product type
Operating frequency range
Attenuation
Antenna base connector
Pigtail connector
VSWR
Maximum input power
Base material
Cable
Environment
1. VSWR = voltage standing -wave radio
System Requirements
The Cisco 3G-AE015-R antenna base is a remote antenna solution for the Cisco 3G wireless WAN
HWICs and should be connected using the 20-ft or 50-ft ultra-low-loss (ULL) cables recommended for
this product. It requires an antenna that uses a TNC (male) connector.
For proper use of the antenna base in conjunction with the Cisco 3G-ANTM-1919D antenna, see the
Cisco Multiband Swivel Mount Dipole Antenna (3G-ANTM1919D)
Installation Notes
Table 1
Table 1
Cisco Antennas Supported on the 3G Wireless HWIC
Cisco Part Number Antenna Type
3G-ANTM1919D Dipole
Omnidirectional
Warning
This equipment must be connected to an indoor antenna only. Statement 373
1
lists the Cisco antennas that are supported for use with the antenna extension base.
Maximum Gain and
Frequency Range
0 dBi
(806–960 MHz)
0 dBi
(1710–2170 MHz)
Single-port antenna base
6 GHz
<3 dB at or below 2.5 GHz
TNC female
TNC male
<2.0
25 Watts
Cisco grey UL94 V0 PC/ABS plastic
15 ft (4.6 m)
Indoor only
document.
Description
This is the default antenna. Multiband faceplate-mounted
dipole antenna. This antenna is included with all
faceplate-mounted 3G wireless WAN HWICs. For more
information, see the
Cisco Multiband- Swivel Mount Dipole
Antenna (3G-ANTM1919D)
Technical Specifications
document.
Book Title
5
Advertisement
Table of Contents
