Section 3 Monitor Options - Honeywell EGPWS MK V Pilot's Manual

The options listed below are set in the RCD and setup during
SECTION 3
the installation of Stabilized Approach Monitor, Altimeter
MONITOR
Monitor, and Long Landing Monitor. The flight crew cannot
Options
configure them.
Monitor Options
Configurable Feature
Distance Unit of Measurement
GPS Antenna Location
Enable/Inhibit Discrete
Stabilized Approach Monitor
Voice Gender
Enable/Inhibit Discrete
Landing Flap Monitor
Upper Flap Gate Alert; Altitude
Lower Flap Gate Alert; Altitude
Excessive Approach Angle Monitor
Excessive Approach Speed Monitor
Altimeter Monitor
Voice Gender
Below Transition Altitude Enable
Above Transition Altitude Enable
Long Landing Monitor
Voice Gender
Configure Callout
Long Landing Distance
Long Landing Percentage
Long Landing Distance Remaining
Long Landing Percentage Remaining
TM
Smart Landing
114
Mark V and Mark VII EGPWS Pilot's Guide
:
Customer-selected location based on aircraft
Takeoff Flap and Long Landing monitors use the
same discrete as Runway Awareness
Off or On; or use the same discrete as Takeoff Flap,
Long Landing and Runway Awareness
Off or On; 500 ft. to 1400 ft., typically 950 ft.
Off or On; 500 ft. to 1000 ft., typically 600 ft.
Off or On; Boeing or Airbus alert curve
"Long Landing" or "Deep Landing"
Distance from the selected end to trigger alert
Off or On; Percentage of runway remaining to
Off or On; Distance from the selected end to trigger
Off or On; Percentage of runway remaining to
trigger distance remaining alert
Option
Feet or Metres
installation
Off or On
Female or Male
Off or On
Off or On
Off or On
Female or Male
Off or On
Off or On
Off or On
Female or Male
trigger alert
distance remaining alert
060-4241-000
Rev H, August 2011